DESCRIPTION:

loopit! consists of 3 looper units.
When triggered, the incoming signal is sampled in 3 different looper units. This produces interesting patterns, using the timbres of the incoming stereo signal.

CONTROLLERS:

ON/OFF - bypass
loop 1/2/3 - activate looper section 1, 2 , 3
trigger - when set to 1, the opcode starts recording until the loop memory is full.
It then plays the looped sound until it is switched off again (ktrig = 0)
looptime - loop duration in seconds
pitch - pitch control (transposition ratio); negative values play the loop back in reverse
loop - gain of each looper section
direct - mix direct signal with effect

---

version 1.33, December 2020
- changed volume of effect mix (lower)
- if not triggerd, no direct signal is mixed in.

version 1.32, July 2020
- added BSB information comments

version 1.31, May 2020
- added comments on controllers

version 1.3, November 2019
- changed mix direct/effect

version 1.2, September 2019
- for mixing effect/direct, changed to only 1 direct signal gain

version 1.1, May 2019
- for mixing effect/direct, changed to only 1 direct signal gain

version 1.0, May 2019
- initial version by Menno Knevel
- 3 independent looper units
- each unit has a mix with incoming signal
- time of loop can be retriggerd while playing