loopit!

DESCRIPTION: loopit! consists of 3 looper units. When triggered, the incoming signal is sampled in 3 different looper units. This produces interesting patterns, using the timbres of the incoming stereo signal. CONTROLLERS: ON/OFF - bypass loop 1/2/3 - activate looper section 1, 2 , 3 trigger - when set to 1, the opcode starts recording until the loop memory is full. It then plays the looped sound until it is switched off again (ktrig = 0) looptime - loop duration in seconds pitch - pitch control (transposition ratio); negative values play the loop back in reverse loop - gain of each looper section direct - mix direct signal with effect --- version 1.33, December 2020 - changed volume of effect mix (lower) - if not triggerd, no direct signal is mixed in. version 1.32, July 2020 - added BSB information comments version 1.31, May 2020 - added comments on controllers version 1.3, November 2019 - changed mix direct/effect version 1.2, September 2019 - for mixing effect/direct, changed to only 1 direct signal gain version 1.1, May 2019 - for mixing effect/direct, changed to only 1 direct signal gain version 1.0, May 2019 - initial version by Menno Knevel - 3 independent looper units - each unit has a mix with incoming signal - time of loop can be retriggerd while playing