Pulsator true 2 2 if (<PulsatorON> == 1) then aoutl waveset ain1, <Pulsator_left repetitions> aoutr waveset ain2, <Pulsator_right repetitions> aout11, aout12 pan2 aoutl, <Pulsator_panning L> aout21, aout22 pan2 aoutr, <Pulsator_panning R> aout1 sum aout11, aout21 aout2 sum aout21, aout22 aout1 = (ain1 * <Pulsator_wetdry>) + (aout1 * (1 - <Pulsator_wetdry>)) aout2 = (ain2 * <Pulsator_wetdry>) + (aout2 * (1 - <Pulsator_wetdry>)) else aout1 = ain1 aout2 = ain2 endif DESCRIPTION: Pulsator, based upon the wavset opcode, takes in the sound and transforms it into repetative cycles or "pulses". CONTROLLERS: ON/OFF - bypass repetitions L/R - the number of times the cycle is repeated for Left and Right channel panning L/R - panning for Left and Right channel wet/dry - mix direct signal with effect --- version 1.02, June 2020 - small code correction version 1.01, May 2020 - added comments on controllers version 1.0, June 2019 - initial version by Menno Knevel 10 5 DOT true 0 0 Group 0x00000033 0x000000ff 0xffffffff true 20 20 PulsatorON 0 0 true 10 10 Group 0x4d8080ff 0x000000ff 0xffffffff false 20 20 Pulsator_left repetitions 10 18 true 1.0 20.0 1 12.0 150 true true 10 20 System Bold 12.0 10 60 System Bold 12.0 Pulsator_panning L 220 10 true 0.0 1.0 0.0 25 true false true System Regular 12.0 Pulsator_wetdry 300 20 true 0.0 1.0 0.5700000000000001 40 true false true System Regular 12.0 Pulsator_right repetitions 10 60 true 1.0 20.0 1 6.0 150 true true Pulsator_panning R 220 50 true 0.0 1.0 1.0 25 true false true System Regular 12.0 50 45 System Regular 12.0